JN0-363 Practice Online

Question 1

You are deploying an MC-LAG connection at the edge of your network to a new customer. This solution must ensure that traffic uses all available links when forwarding traffic between the two networks.In this scenario, which two statements are correct? (Choose two.)

A : Transit traffic sent between the two PE devices will use the ICL interface.

B : You must use active/active mode when defining the MC-LAG bundle.

C : You must use active/standby mode when defining the MC-LAG bundle.

D : Transit traffic sent between the two PE devices will use the bundle’s member interfaces.

Answer: A,B

Question 2

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority

has been configured. Which statement is true in this scenario?

A : device with the lowest MAC address will be elected as the root bridge.

B : device with the highest MAC address will be elected as the root bridge.

C : device with the lowest numerical lo0 IP address will be elected as the root bridge.

D : device with the highest numerical lo0 IP address will be elected as The bridge.

Answer: A

Question 3

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

A : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will be dropped.

B : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will be dropped.

C : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will egress ge-1/0/4 with an outer VLAN tag of 200.

D : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will egress ge-1/0/4 with an outer VLAN tag of 200

Answer: A,C

Question 4

Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24,

172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route

hidden.

Which action would you perform to determine the problem?

A :

Verify that you have active contributing routes on the device.

B :

Verify that you have configured a policy on the device to accept aggregate routes.

C :

Verify that you have defined a metric value for the aggregate route.

D :

Verify that you have set the preference to a lower default value.

Answer: D

Question 5

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

A : ue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : der the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : ue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : der the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Name:	Service Provider Routing and Switching Specialist (JNCIS-SP)
Exam Code:	JN0-363
Certification:	Service Provider Routing and Switching
Vendor:	Juniper
Total Questions:	100
Last Updated:	Jan 07, 2025

Download Demo JN0-363 Dumps

Create Account

Password Recovery

JN0-363 Practice Online

Download Demo JN0-363 Dumps

Member Login

Create Account

Password Recovery

JN0-363 Practice Online